Free Cisco 500-220 Exam Questions & Answer from Training Expert Prep4away
Top Cisco 500-220 Courses Online
Cisco 500-220 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
| Topic 13 |
|
NEW QUESTION 15
For which two reasons can an organization become "Out of License"? (Choose two.)
- A. expired device license
- B. MR licenses that do not match the MR models in the organization
- C. licenses that do not match the serial numbers in the organization
- D. more hardware devices than device licenses
- E. licenses that are in the wrong network
Answer: A,D
NEW QUESTION 16
Which design requirement is met by implementing syslog versus SNMP?
- A. when proactive alerts for critical events must be generated
- B. when organization-wide information must be collected
- C. when automation capabilities are needed
- D. when information such as flows and client connectivity must be gathered
Answer: D
Explanation:
Reference:
Meraki_Device_Reporting_-_Syslog%2C_SNMP%2C_and_API
NEW QUESTION 17
A customer requires a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection.
How many tunnels does each hub need to support?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 18
What are two ways peers interact with ports that Auto VPN uses? (Choose two.)
- A. Peers contact the VPN registry at TCP port 9350.
- B. Peers contact the VPN registry at UDP port 9350.
- C. For IPsec tunneling, peers use UDP ports 500 and 4500.
- D. For IPsec tunneling, peers use high TCP ports within the 32768 to 61000 range.
- E. For IPsec tunneling, peers use high UDP ports within the 32768 to 61000 range.
Answer: B,D
Explanation:
Reference:
_Configuration_and_Troubleshooting
NEW QUESTION 19
Refer to the exhibit.
Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?
- A. WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the "Conf" performance class.
- B. WebEx traffic will prefer WAN 1 as it is the primary uplink.
- C. WebEx traffic will be load-balanced between both active WAN links.
- D. WebEx traffic will prefer WAN 2 as long as it is up.
Answer: B
NEW QUESTION 20
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Latency
- B. Per-flow Goodput
- C. Total Bandwidth Usage
- D. Maximum Jitter
- E. Application Response Time
Answer: B,E
NEW QUESTION 21
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Firewall & traffic shaping
- B. Controller disconnection behavior
- C. Captive Portal strength
- D. Simultaneous logins
- E. RADIUS for splash page settings
Answer: B,C
NEW QUESTION 22
Refer to the exhibit.
A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?
- A. Not enough detail is available to determine the next hop.
- B. The Auto VPN peer "Store 1532 - appliance" is the next hop.
- C. The packet is stopped.
- D. The concentrator gateway (10.128.124.62) is the next hop.
Answer: A
NEW QUESTION 23
Refer to the exhibit.
For an AP that displays this alert, which network access control method must be in use?
- A. splash page with my RADIUS server
- B. preshared key
- C. MAC-based access control with RADIUS server
- D. WPA2-enterprise with my RADIUS server
Answer: B
NEW QUESTION 24
Refer to the exhibit.
The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?
- A. Remove the connection from Internet 1.
- B. Physically disconnect all LAN ports.
- C. Add a deny any/any firewall rule to the end of the firewall rules.
- D. Configure the MX appliance to Routed mode on the Addressing & VLANS page.
Answer: B
NEW QUESTION 25
Where should a network admin navigate to investigate wireless mesh information between Meraki APs?
- A. Wireless > Configure > Radio Settings
- B. Wireless > Monitor > Wireless Health
- C. Wireless > Monitor > Access Points > AP > RF
- D. Wireless > Monitor > RF Spectrum
Answer: C
NEW QUESTION 26
Which information do the MXs in a High Availability pair share?
- A. time synchronization state
- B. stateful firewall database
- C. DHCP association database
- D. spanning-tree state
Answer: D
NEW QUESTION 27
One thousand concurrent users stream video to their laptops. A 30/70 split between 2.4 GHz and 5 GHz is used.
Based on client count, how many APs (rounded to the nearest whole number) are needed?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 28
Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?
- A. starts on both MX appliances at the same time and then immediately reboots both appliances
- B. starts on the secondary MX appliance and then occurs on the primary MX appliance
- C. starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases
- D. starts on the primary MX appliance and then occurs on the secondary MX appliance
Answer: D
NEW QUESTION 29
Which API endpoint clones a new Organization?
- A. POST /organizations/{organizationId}/clone
- B. POST /organizations/clone/{organizationId}
- C. POST /organizations/{organizationId}/new
- D. PUT /organizations/{organizationId}/clone
Answer: C
NEW QUESTION 30
Drag and drop the descriptions from the left onto the corresponding MX operation mode on the right.
Answer:
Explanation:
NEW QUESTION 31
Refer to the exhibit.
What are two outcomes reflected in the Web App Health application? (Choose two.)
- A. Neither network recorded any server-side performance issues.
- B. Users on both networks may be experiencing issues when attempting to reach Google.
- C. Network #2 had better application performance than Network #1.
- D. Network #1 could not load Google because of a remote server issue.
- E. Network #2 could not load Google because of a local client misconfiguration.
Answer: A,D
NEW QUESTION 32
What are two organization permission types? (Choose two.)
- A. Full
- B. Write-only
- C. Monitor-only
- D. Read-only
- E. Write
Answer: A,D
Explanation:
Reference:
Managing_Dashboard_Administrators_and_Permissions
NEW QUESTION 33
Which Meraki Dashboard menu section is accessed to enable Sentry enrollment on an SSID?
- A. Wireless > Configure > Firewall & Traffic Shaping
- B. Wireless > Configure > Access Control
- C. Wireless > Configure > Splash page
- D. Wireless > Configure > SSIDs
Answer: B
NEW QUESTION 34
In an organization that uses the Co-Termination licensing model, which two operations enable licenses to be applied? (Choose two.)
- A. License more devices.
- B. Call Meraki support.
- C. Renew the Dashboard license.
- D. Wait for the devices to auto-renew.
- E. License a network.
Answer: A,C
Explanation:
Reference:
Termination_Licensing_Overview
NEW QUESTION 35
......
New (2021) Cisco 500-220 Exam Dumps: https://www.prep4away.com/Cisco-certification/braindumps.500-220.ete.file.html
500-220 Practice Dumps - Verified By Prep4away Updated 58 Questions: https://drive.google.com/open?id=1FlcJBuNKVN3BHqjkcByNsINnjcK2Tlil